Hello,
I try to upgrade a KRC2 Edition (not ED05 control cabinet)
what i did first :
1- Upgraded motherboard CELERON 466Mhz from 128 Mo RAM to 256 Mo (minimum to start with this kind of software)
2- Installed new hard disk clone from a KRC2 ED05 with software V5.4.14
3-Installed file KRC2.BIN from old install CD software v4.1.7 in the folder KRC\ROBOTER\ DSE from the hard drive.
After booting Windows XP and the software v5.4.14 loaded successfully but i have still some issues :
Error Code 55 - DSE Initialization
Error Code 244- Software version not correct DSE1
Error Code 310 – Safety Circuit for drives not ready
I used diagnostic function to check status from the MFC2/ DSE :
MFC2 (V4) ISA port recognized and green status
DSE IBS C32 60MHZ KRC2 SW version 1.0 SW revision 0 recognized and green status
RDW2 recognized and green status. (i uploaded succesfully datas from the RDW2 to the hard disk also)
When i inspected inside the control cabinet all green LEDs were blinking normally on the KPS and on all KSD .
So i think that i don t have the right DSE (i saw in previous post that DSE C32 3.02 is working on MFC2 without hardware changes or change for a DSE C33 on MFC2 but with hardware changes on X11 and ESC card.
What do you think about that?
Thanks in advance.